ERRATA FOR 9912 Board

Silkscreen Errors:
Reference is with the PIC section on the left.
Top of Board:
C50,C51,C52,C53 missing.  They are the 4 caps left of the 9912 just right of the middle shield.
R13 missing:  R13 is between SW2 and D3 in the PIC section on top.
R2 missing:   R2 is just above lower left mounting hole left of H3
D1 missing:   D1 is just above the H3 designator.
FL1 missing:  FL1 is at the top of the board above T2.

Bottom of Board:
C25 is Missing:  C25 is at bottom just below U9.
C22 is missing:  C22 is at bottom just below U6.

Connections:
 In order for the DDS to accept commands from the PIC, CSB must be tied low.  A jumper between H7-5(CSB) and H7-5(GND) can be added.  Alternately, H7-5 can be connected to a PIC output pin for PIC control of the line.  The production board will have a 10K to ground on the CSB line.

 The footprints for regulators U6 to U12 are a little too wide.  The regulators can still be soldered on the board without modifications, but alignment is more critical.  The production board has the correct footprints.